How to Perform a Power Steering Flush

#driveyourlife

power steering flushPerforming a power steering flush is definitely a procedure you can do in your garage with a few hours on Saturday morning with a little know-how and a good set of hand tools.  A power steering flush is something that your car needs if your power steering fluid looks dark.  Power steering fluid is usually a light golden or bright red/pink color.

You can check the condition of your power steering fluid by locating the reservoir, removing the cap and peaking in.  If the fluid looks dark or contaminated try wiping a little of it on a white paper towel either from the dipstick or by dipping a clean corner of the cloth in the fluid.  With the fluid on the white towel, you should be able to tell quickly if it looks clean or it’s time for a flush.

A flush is better than simply changing the power steering fluid because it removes all the old fluid and replaces it with clean fluid.  When changing your power steering fluid, the reservoir is simply sucked dry and new fluid added there.  This leaves lots of old fluid still in the pump, lines and steering rack which then will contaminate your new fluid.  You would have to empty and refill the reservoir multiple times to get your power steering fluid looking clean again and each consecutive time you would be removing some of the new fluid you added that had mixed with the old fluid wasting money.

As we mentioned, performing a power steering fluid flush doesn’t require any fancy tools.  You can use your power steering pump to pump out the old fluid and install new fluid in the reservoir.

The start your power steering flush, pump all of the old fluid out of the reservoir then refill it with new, clean power steering fluid.  Next, locate a low-pressure line in your power steering system.  The low-pressure lines will run from the steering rack or gear back up to the power steering fluid reservoir.  If you can find one in the front of your vehicle and low on the chassis it will make things easier.  Many vehicles have a power steering cooler at the front of the vehicle in front of the radiator or condenser.  These lines make great choices for a power steering flush.

Next, disconnect the low-pressure line you’ve found and feed it to an oil drain pan.  You may need to add a length of rubber hose to keep from making a mess.  If the line is a hard line, consider using a line wrench to keep from rounding the nut.

It can be helpful to have someone help with the next step, but the goal is to start your vehicle’s engine and allow the power steering pump to pull the new fluid out of the reservoir and push the old fluid out of the low-pressure line you disconnected.  You need to make sure the reservoir always has fluid in it to keep air from being drawn into the system so it can be helpful to have your friend start the car and keep an eye on the drain pan while you keep the reservoir full.

Once clean, new fluid is running out of the low-pressure line, shut off the engine, reconnect the line, burp the system and top of your reservoir with new fluid!

If you’re looking the best power steering fluid to use for your power steering flush, consider using BlueDevil Synthetic Power Steering Fluid.  BlueDevil Synthetic Power Steering Fluid can be used in place of any factory power steering fluid and will help maintain your power steering system preventing future wear and problems!

You can find BlueDevil Synthetic Power Steering Fluid at any of our partnering local auto parts stores like:

  • AutoZone
  • Advance Auto Parts
  • Bennett Auto Supply
  • CarQuest Auto Parts
  • NAPA Auto Parts
  • O’Reilly Auto Parts
  • Pep Boys
  • Fast Track
  • Bumper to Bumper Auto Parts Specialists
  • S&E Quick Lube Distributor
  • DYK Automotive
  • Fisher Auto Parts stores
  • Auto Plus Auto Parts stores
  • Hovis Auto & Truck Supply stores
  • Salvo Auto Parts
  • Advantage Auto Stores
  • Genuine Auto Parts stores
  • Bond Auto Parts stores
  • Tidewater Fleet Supply
  • Bumper to Bumper Auto Parts
  • Any Part Auto Parts
  • Consumer Auto Parts

Pictures Provided By:

power_steering_flush.jpg – By MG_54 – Licensed by Getty Images – Original Link

BlueDevil Products can be found on Amazon.com or at AutoZone, Advance Auto Parts, O’Reilly Auto Parts, NAPA, and other major auto parts retailers.

27 responses to "How to Perform a Power Steering Flush"

27 Comments

  1. Amin on September 28, 2017 at 5:57 am

    My Toyota Sienna Steering is soft but making a loud noice when not in motion when I start speeding the sound reduces. My mechanic told me I have to get a new power steering but I doubt the decision

    • BD Auto Pro on September 28, 2017 at 3:59 pm

      Amin,

      Thanks for your question about your Toyota Sienna. If you’ve got a noisy power steering system, the first thing to do would be to check your fluid level. If the level is low, top it off and add BlueDevil Power Steering Stop Leak (available here: http://store.gobdp.com/power-steering-stop-leak-00232/) to seal the leak and keep the noise from coming back. If your level isn’t low, it’s possible you’ve got a clog that is raising pressures at low engine RPM causing the noise you’re hearing. You could try a power steering flush to remove the clog, but at the end of the day, you may need to simply replace the line or component the clog is in.

      Thanks again for your question!
      -BD Auto Pro

    • Aw on April 18, 2024 at 11:40 pm

      Mine made a loud noise that got quieter the faster I went. Spark plugs blew a few days later. Do a code reader thing to see if it’s got any codes yet

  2. Faisal Butt on May 30, 2019 at 4:33 pm

    I’ve Mazda6 2008, when I start my car and move steering wheel or try to park, steering making noise, power steering fluid level is good and it looks fine..So what i have to do..?

    • BlueDevil Pro on May 31, 2019 at 9:03 am

      Faisal-

      Thank you for asking about your Mazda 6. Is the noise you are hearing like a whining noise? A whining noise can indicate that there is air trapped in the system, or that the power steering fluid as lost its lubricating properties. Please contact our technical support line at 888-863-0426 so that we can get a little better understanding of the vehicle’s condition and be able to make any appropriate recommendations.

      Thank you!

      -BDP

      • Mora Tolentino on April 18, 2024 at 6:53 pm

        I have a 2010 f-150 I changed the power steering pump everybody’s telling me I got Aaron the line because it’s so hard to turn hi jacked up the front end three individual times and turn the steering wheel for about half hour it is still hard to turn I did a power steering flush and it’s still hard to turn is there a certain way to get the air out

        • BlueDevil Pro on April 19, 2024 at 2:23 pm

          Mora-

          Thank you for asking about your Ford F-150. To bleed the air out of the power steering system, first start by opening the bleed valve slightly. Turn the steering wheel several times lock to lock. Top off the power steering fluid once the air is no longer in there (once the fluid has stopped bubbling out). Close the bleed valve and turn the steering wheel a few more times and check the fluid level once more before driving.

          Thank you!

          -BDP

  3. Michael Luensmann on July 26, 2019 at 3:51 pm

    I have an 06 Cadillac STS. My power steering symptoms go in cycles. Sometimes it normal. Sometimes it’s real hard. Then sometimes it’s hard until a hard turn then the system breaks loose and it will stay normal the rest of the trip or sometimes stay normal for awhile. Then the process starts all over again. Fluid level good, system burped, color good, no noise. Any thoughts?

    • BlueDevil Pro on July 29, 2019 at 9:33 am

      Michael-

      Thank you for asking about your Cadillac STS. Based on your description, it’s possible that debris/dirt are causing the fluid not to be able to circulate all throughout the system. Performing a power steering flush should remove any debris and return the system to normal. Another possibility is that there could be an issue with the power steering pump not pumping the fluid through routinely, however, typically you may hear a whining noise associated.

      Thank you!

      -BDP

  4. Emmen on November 5, 2019 at 10:16 am

    Some questions about your procedure.

    I will be working on a Buick enclave. Is there an ideal location to open the line?

    How do I burp the system?

    When I start the engine, I assume the pump will pump out the fluid ? How fast does it typically come out a few seconds or a few minutes?

    • BlueDevil Pro on November 5, 2019 at 10:52 am

      Emmen-

      Thank you for asking about your Buick Enclave. The low-pressure lines will run from the steering rack or gear back up to the power steering fluid reservoir.  If you can find one in the front of your vehicle and low on the chassis it will make things easier. To burp the system, start the engine, remove the power steering reservoir cap and turn the steering wheel back and forth a couple of times to get the fluid circulating. The fluid will start to burp itself out and you should top it off with power steering fluid from there.

      Thank you!

      -BDP

  5. Luke D'Ambrosio on October 17, 2020 at 4:46 pm

    I have a 1993 Isuzu Rodeo. I have replaced the power steering pump 3 times and each time it feels like there is no power steering at idle. When I bring the RPMs up the steering is fine. What do I do?

    • BD Auto Pro on October 20, 2020 at 9:42 pm

      Luke,

      Thanks for your question about your 1993 Isuzu Rodeo. Many vehicles don’t make good power steering pressure at idle and have some sort of idle up system that raises the engine idle when you turn your steering wheel so we would recommend checking that system to make sure it’s working. Assuming you’ve got a good power steering pump then you probably have a clog somewhere in the system which is reducing the pressure to the steering gear.

      Thanks again for your question!
      -BD Auto Pro

  6. Jen on January 28, 2021 at 8:33 am

    I got power steering fluid on my clothes. How do I get it out? I have used vinegar, baking soda, Google Gone, Dawn, & Oxiclean

    • BlueDevil Pro on January 28, 2021 at 9:25 am

      Jen-

      Letting the clothes soak in warm water and baking soda for about an hour, and then washing the clothes as normal with the washing machine should help remove the stain/odor left behind by the power steering fluid.

      Hope this helps!

      -BDP

  7. martin bailey on February 11, 2021 at 6:44 am

    how to change and where is the power steering fluid on a 95 holden rodeo petrol thank you

    • BlueDevil Pro on February 11, 2021 at 8:22 am

      Martin-

      When looking under the hood, you should be able to locate the cap for the power steering reservoir. If you are unable to locate the power steering cap, you may be able to look up a diagram of the assembly online.

      Hope this helps!

      -BDP

  8. Michael J Roland on February 17, 2021 at 5:19 am

    I have a 2000 Buick Lesebra Custom and the power steering is not working for it is so hard to steer and turn, what do you recommend?

    • BlueDevil Pro on February 17, 2021 at 8:52 am

      Michael-

      Thank you for asking about your Buick LeSabre. Does the power steering fluid appear low? If so, we recommend using the BlueDevil Power Steering Stop Leak to help stop the loss of power steering fluid and return your power steering. You would start off by adding 1/3 of the bottle into the power steering reservoir and topping the rest off with power steering fluid. Be sure not to overfill. You should expect to start seeing results after 100-200 miles of driving.

      Thank you!

      -BDP

  9. Bran Keippala on July 31, 2021 at 8:48 am

    Thanks for the great article and all the advice you have given other commenters. I’m really impressed!

  10. Marguerite Gardner on September 21, 2021 at 9:31 pm

    It was recommended by my dealership for a power steering flush. My 2016 Jeep Compass wil lock up during turning. I turn the car off wait turn flashes on then it works again. Is this the right recommendation for the problem I am experiencing?

    • BlueDevil Pro on September 22, 2021 at 8:26 am

      Marguerite-

      Thank you for asking about your Jeep Compass. Based on your description, flushing the power steering fluid and bleeding the lines of air would be the best recommendation to start. It is not common for the power steering fluid to go bad, however, sediment or debris could be restricting the power steering pump from circulating the fluid properly. Flushing the system would be the best remedy in this case.

      Thank you!

      -BDP

  11. Kayla on January 27, 2023 at 7:25 am

    Would my 2007 hyundai sonata be hard to steer and making grinding noises when I turn due to needing a flush? Or do you think my power steering pump went out completely?

    • BlueDevil Pro on January 27, 2023 at 8:27 am

      Kayla-

      Thank you for asking about your Hyundai Sonata. Does the power steering reservoir appear to be low on fluid? If the fluid is reading at the proper level, flushing the power steering unit and refilling with fresh, clean fluid, would be a great place to start. If the problem persists, you may want to bring the vehicle to your local mechanic for inspection.

      Thank you!

      -BDP

  12. Peter L on November 5, 2023 at 7:12 pm

    What the hell does “burp the system” mean?

    Otherwise a good explanation.

    • BlueDevil Pro on November 6, 2023 at 8:59 am

      Peter-

      “Burp the system” or bleeding the system, refers to removing any tiny air pockets that are trapped within the system.

      Thank you!

      -BDP

  13. Asjad Emir on November 30, 2023 at 4:34 am

    It was great guide. Thank you. autocornerd

Leave a Reply





Related Articles

Search Blog

Subscribe

Blog Categories